User Guide
Preparation Before Use
(1) Assembling the Shell
Insert the long pole into the outer sleeve along the edge of the shell.
Push one end of the pole all the way into the sleeve, then insert the other end into the opposite sleeve to secure it.
Next, insert the short pole into the inner sleeve at the center of the shell.
Once it reaches the end, slightly bend the pole and insert the other end into the sleeve to fix it in place.
(2) Inserting the Belts into the Child Seat
The belt insertion points of the shell may vary depending on your child seat model.
Please select your compatible model from the list below and follow the instructional video to insert the belts correctly into the child seat.
- Thule Yepp Maxi
- Thule Yepp 2 Maxi
- Thule Yepp Nexxt Maxi / 2 Maxi
- Hamax Zenith
- Hamax Kiss
- Polisport Guppy Maxi
- Bobike GO Maxi
Thule Yepp Maxi
Thule Yepp 2 Maxi
Thule Yepp Nexxt Maxi / 2 Maxi
Hamax Zenith
Hamax Kiss
Polisport Guppy Maxi
Bobike GO Maxi
(3) Securing the Shell on the Child Seat
After inserting the shell’s belts into the child seat, secure the belts firmly.
Make sure the belts pass through the designated sleeves.
Once the shell is fixed, check that it is centered on the child seat, then tighten the belts again to ensure a stable and secure fit.
How to Use
(1) Attaching the Rain Cover
The rain cover can be stored inside the back of the shell when not in use.
To attach it, start by fastening the buckle on the right side (in the direction of travel), then close the zipper.
As shown in the instructional video, make sure to fasten all buckles on both sides and the back securely.
(2) Getting Your Child In and Out
To let your child in or out, first unfasten the buckle at the back, then unfasten the buckle on the left side (in the direction of travel) and open the zipper. This allows for quick and easy access for your child.